Safety, placement and storage
Place Grillbooster there, where you normally use your starter chimney*. so on surface which can withhold heat
Grillbooster get just as warm as you starter chimney.
That said Grillboosters build in handle is by, normal use – handwarm.
But be sure before grabbing it always double check carefully .
When done with Grillbooster place it on a safe spot normally where you place your hot starter chimney.
!!! NEVER leave your filled with burning stuf in a turned off Grillbooster.
The intense heat will kill your Grillbooster.
Quick Guide
in general
Grillbooster has 3 phases, start-up full speed and finally cooling down.
start up (slow pace for 60 seconds and blinking LED
full speed max speed no time limit only you or empty battery will stop it . Steady LED
cooling down half speed for a couple of minutes blue LED
When you start the Grillbooster it runs 60 seconds slowly automatically shifts to full speed. When you stop is warns you if low battery and then runs for a couple of minutes the cooling down blue LED. it shuts it selves down with a final battery status. in case you missed the first one.
Start/Stop
Push the button until you hear a beep
LED while Grillbooster in action
Green blinking: low speed so the briquettes will get lit.
You can skip stip part if you want by pressing the button shortly
Green: Grillbooster runs at full speed
Blue: Cooling down
Battery Check
When Grillbooster is switch off – shortly press the push button
when you stop it will check and warn you when too low by beeps and red LED
Battery status
Green: your are good to go
Orange: you can do a run but optil 30 minutes (you should keep a eye to the Grillbooster)
Red: Recharge the battery before you can run
How to skip the start-up phase
Our experience is the most combination of fire-starters and briquettes need a slow start. too much wind and the briquettes will not be let properly in the start. This can delay the process or even dy out and you have to start all over again.
That is why Grillbooster runs the first 60 seconds on slow speed. But no worries it will automatically go to full speed.
But if your combination of fire-starters and Briquettes doesn’t need a slow start just press after starter one more time and you will skip the start-up.